• seperator

Scarce enough to hoard?

April Mint production numbers have been released and those who have an interest have been focusing heavily on cents, nickels and dimes.

The cents make a natural focus because of the attention being paid to the four new designs this year, the second of which will reach the public beginning May 14. Almost 230 million more have been produced, all being of the second Lincoln design. This number leaves it on track to match the output for the first design, but of course, one month’s production does not guarantee a pattern any further than to confirm a Mint preference to run at a fairly even pace.

Nickels and dimes are being scrutinized because there might not be any more struck this year. Through April, nickel production was just under 40 million at each of the two circulating coin production facilities in Philadelphia and Denver.

Dime production is higher than nickel production, reaching almost 100 million at Philadelphia and 50 million at Denver.

So what do I do? I decided to look at the Territorial quarter mintages.

What do they show? In the month of April Philadelphia struck 26.52 million coins. These are all very likely the Guam design. Denver struck 19.6 million.

Since there are six designs this year, that leaves two production months for each design, though striking the D.C. quarter began before the beginning of the calendar year.

If the quarter numbers are half of a two-month run, Guam totals would fall from the Puerto Rican mintage totals, but by less than you might think. Philadelphia would be on track to match its Puerto Rico ouput, and Denver would drop from 86 million to roughly 40 million, or 39.2 million if you precisely double the 19.6 million April production total.

May production could rise, knocking these numbers into a cocked hat, or the production rate could fall yet further, amplifying the sense of scarcity among collectors.

Mintages of 40 million or 50 million quarters is a novelty for collectors because it has been almost a half century since numbers like these were the norm.

Collectors being collectors will likely pay close attention to these numbers and perhaps squirrel away more of them than they should.

The low 1955 output caused that year to stand out for Washington quarter collectors, but because collectors of the time were guided by the mintage totals, quite a few have survived in high grades. The 1955-D has a mintage of just about 3.2 million, but right on up to about MS-63, the prices for the coin hardly differ from issues with 10 times that mintage.

Will that kind of pricing wll play out for Territorial quarters 50 years from now?

This entry was posted in Buzz. Bookmark the permalink.

2 Responses to Scarce enough to hoard?

  1. Mark says:

    I bought the silver quarters set and will order the 2009 proof set when it comes out for the remaing 2009 coins. I usually don’t order the uncirculated stets, but since I have found no 2009 coins in change this year, and none of the banks I have gone to have any plans to order them, I might purchase it this year.

  2. Dime production has not been this low since 1955 and we have to go back to 1951 to find nickel production this low–assuming no more coins are struck this year. While those who grew up in the 1950’s look back at it nostalgically for its simplicity and calmer approach to life, it was a time of stagnant growth for the country–which is reflected by the mintage totals of the period.

    It would be interesting to see the trend lines plotted of this year’s production versus years past.

Leave a Reply